Scubapro Nova 250 Guia De Inicio Rapido página 3

INSTRUCTIONS
Make sure to not over tighten the casing as this
could result in premature wear and/or damage
to the O-rings.
*NEVER USE A TOOL OF ANY KIND TO
TIGHTEN THE CASE*
To turn ON the SCUBAPRO Nova 250 full
press the button at the rear of the light and the
light turns on. To switch between 100%, 25%
and STROBE mode just half press the button.
To turn OFF the Nova 250 full press the button
again and the light turns off.
! WARNING
Do not look directly into the light, or direct
the light into the eyes of others. Do not
alter or modify the dive light. If modification
causes water entry or other malfunctions,
the warranty will be void.
The light is fitted with an overpressure
valve for your safety. In case the battery
produces gas leading to a high internal
pressure of the light, the valve will open.
This could cause water to enter the light.
Proper storage: if the dive light is not to be
used for a long period of time, remove batteries
to avoid accidental leakage.
Proper maintenance: frequent use of the dive
light may cause O-rings to dry out. To avoid
leakage, clean O-ring groove with a cotton
swab and regularly apply lubricant to O-rings
to help prevent dry cracking. Please rinse the
Nova 250 with fresh water before storing.
3