Safety Information - Allen + Roth CO.VS200 Instrucciones De Ensamble

HARDWARE CONTENTS (shown actual size)
AA
BB
1 in.
Screw
1-1/4 in.
Screw
Qty. 2
Qty. 8

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product. If you have any questions regarding the product, please call customer service.
WARNING
• Two people are required to safely install this vanity. Take extra precautionary measures to ensure
a secure grip on the vanity when lifting.
CAUTION
• Do not use water that exceeds a temperature of 140
• Avoid placing the furniture in direct sunlight.
• Avoid exposing the furniture to extreme temperatures by installing away from heat and air vents.
• The bathroom floor must be finished prior to installation of the vanity.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents above. If any part is missing or damaged, do not
attempt to assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 5 hours (includes drying time for silicone adhesive)
Tools Required for Assembly (not included): Tape Measure, Electric Drill with 2 in. Drill Bit, Level,
Phillips Screwdriver, Silicone.
Helpful Tools (not included): Stud Finder, (2) M8 x 2 in. Screws and (2) Wall Anchors (if mounting
vanity to wall).
Before installing your new vanity, first remove the old vanity (if applicable). Turn off the water supply
and drain out. Disconnect the supply lines from the faucet. Note: If the new vanity is not installed
immediately, temporarily stuff a rag into the drain pipes.
CC
Allen key
Qty. 1
0 F/46 0 C.
3
DD
Knob
Shelf Support
Qty. 2
Qty. 4
EE