Pfeiffer Vacuum CENTERONE Instrucciones De Instalación página 9

CONTROL terminal
(CenterOne)
Pin Signal
3 Status
4 HV_H / HV_EMI
5 Infeed ground (GND)
6 n.c.
7 Degas
8 Infeed (+24 V DC)
9 n.c.
10 Identification
11 Infeed (+24 V DC)
12 Signal ground
13 RxD
14 TxD
15 Housing
Fig. 11: Sub-D socket
This terminal can be used to:
● read out the measuring signal,
● perform an isolated evaluation of the state of the switching function and error monitor-
ing,
● switch the high-vacuum measuring circuit on and off (only with the cold-cathode trans-
mitter PTR 225).
Dangerous contact voltage
Voltages above 30 V AC or 60 V DC are deemed to be dangerous in the event of contact
in accordance with EN 61010.
 Only apply a grounded protective extra-low voltage (PELV).
 Connect peripheral components with a shielded connecting cable (electromagnetic
compatibility) to the CONTROL terminal on the back of the device.
Pin assignment and contact positions
The pins on the 15-pin sub-D connector are assigned as follows:
Pin Signal
1 Analog output -5 ... +13 V DC
2 Analog output GND
Switch function 1
3
4
5
6 HV_V on (+ 24 V)
HV_H off (0 V)
7 +24 V DC, 200 mA
8 GND = housing
DANGER
2)
Pressure higher than
threshold or device
switched off
1)
1)
Installation
Pressure lower than
threshold
9