Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Wireless Keyboard & Mouse Kit Quick Installation Guide
Hardware Installation
Slide Switch Setting
Make sure your PC is switched off.
1.
Take the receiver and select channel CH1 or CH2 by
2.
using the slide switch on the back of the receiver.
(Remember your selection.)
Connect the receiver to your PC by plugging in the
3.
receiver's green connector into the mouse port of
your PC and the purple connector into the keyboard.
Take the keyboard and make sure the batteries on
4.
the back are installed correctly. (Follow the polarity
signs in the battery compartment.)
5.
Use the slide switch on the back of the keyboard to
select the same channel as the one selected in step 2
on the receiver.
6.
Take the mouse and make sure the batteries on the
back are installed correctly. (Follow the polarity signs
in the battery compartment.)
7.
Use the slide switch on the back of the mouse to
select the same channel as the one selected in step 2
and 5.
ID Button Setting
This ID-recognition function helps to protect against interference
from other RF keyboards in the same environment. Remember to
set the ID when you replace the batteries or your keyboard kits do
not work properly.
The word CONNECT labels the ID button on each unit.
The LED under ID button of receiver shows connecting condition.
1.
Your PC must be on to change the ID setting.
2.
Press ID button on the top of the receiver once.
3.
Press ID button on the bottom of the mouse once
4.
Press ID button on the bottom of the keyboard once.
Software Installation
Keyboard Driver Installation
In order to take advantage of the special button functionality of the keyboard you will have to install the
keyboard driver which is located on the driver CD included in the box.
1.
Insert the driver CD into your drive.
2.
Run the SetupKey.exe in the \9013RF&9001ARF\keyboard software directory of the driver CD.
3.
Follow the on screen instructions to finish the installation procedure.
Mouse Driver Installation
In order to take advantage of the special shortcut button functionality of the mouse you will have to
install the mouse driver which is located on the driver CD included in the box.
1.
Make sure the driver CD is in your drive.
2.
Run the setup.exe in the \9013RF&9001ARF\mouse software directory of the driver CD.
3.
Follow the onscreen instructions to finish the installation procedure.
Keyboard Connector
Mouse Connector
(-)
Battery 1.5V 2pcs
(+)
CHANNEL SWITCH
ID BUTTON
Slide Switch of
Bottom View of Mouse
ID Button
ID Button of Receiver
CHANNEL SWITCH
ID BUTTON
ID Button of Mouse
CH2
CH1
ID Button
ID Button of Keyboard
9013RF QG 英
3100505770 v1.1
CH2
CH1
ID Button
Slide Switch
Setting
Publicidad
