Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 36506F
Wrenches: 16mm
Drill Bits: NONE
j
Hex Bolt – m10 x 1.25 x 30mm CL 8.8
Qty. (4)
1. Raise hitch into position aligning slots in hitch with existing weld nuts in the bottom of frame.
2. Loosely install the M10 hex bolts with conical washers, (4) four places, as shown.
3. Tighten all M10 CL8.8 fasteners with torque wrench.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2010, 2012 Cequent Performance Products
Installation Instructions
HYUNDAI TUCSON
KIA SPORTAGE
EXCEPT KIA SPORTAGE TURBO
FASCIA
Drawbar Kit:
Drawbar must be used in the
RISE position only.
j k
Tighten all M10 CL 8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 n*m)
36051
FRAME
EXISTING WELD NUTS
BOTH SIDES
KIA SPORTAGE
k
Conical Washer – 7/16"
Qty. (4)
Sheet 1 of 3
Part Numbers:
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
3500 LB (1589 Kg.) Max Gross Trailer Weight
300 LB (136 Kg.) Max Tongue Weight
Wiring Access Location: SUV1, SUV2 (Tucson)
SUV1, SUV5 (Sportage)
HYUNDAI TUCSON
j k
36506N
1-11-12
Form F206 Rev A 5605
36506
90129
06994
Rev. C
Publicidad
Manuales relacionados para Cequent Performance Products 36506
Resumen de contenidos para Cequent Performance Products 36506
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. 2010, 2012 Cequent Performance Products Sheet 1 of 3 36506N 1-11-12 Rev.
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. 2010, 2012 Cequent Performance Products Feuille 2 de 3 36506N 1-11-12 Rev.
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. 2010, 2012 Cequent Performance Products Hoj a 3 de 3 36506N 1-11-12 Rev.