Installation - Boston Acoustics Designer Serie Manual Del Usuario

Installation

3
1. Make a 6 ⁄ " (172mm) cutout using the supplied template. It is not necessary to remove fiberglass insulation that may be
4
behind the wall.
2. Run wire from the amplifier to the cutout. Allow an extra foot of wire at the cutout. Strip
wire, and tightly twist the wire strands.
3. Remove the speaker grille. Carefully pry on one side with an awl or small screwdriver.
4. Connect the wire to the speaker. Maintain consistency of the + (red) and – (black) connections by using the markings on
the wire. Failure to do so will result in degraded sound. There are several ways that wire strands are identified:
Smooth/ribbed Smooth/one rib or stripe
8
All manuals and user guides at all-guides.com
Different colored wires
3
Cut a 6 ⁄ " (172mm) hole
4
Utility knife
1
⁄ " (12mm) of insulation off the
2
Fabric strand
Attach the wires to the terminals