Tripp-Lite DWM3780XOUT Manual Del Usuario página 5

Assembly
1B
Mount on Solid Brick or Concrete Block
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or "cinder block"), verify
that the actual concrete thickness is at least 1 3/8" (35 mm) in order to hold the concrete anchors. DO NOT
DRILL INTO MORTAR JOINTS! Be sure to mount the assembled wall-mount plate with the included concrete
anchors, washers and anchor bolts onto solid sections of the blocks. The solid sections can generally
be found 1" (25 mm) toward the middle of the block from either end. An electric drill on a slow setting is
suggested to drill the hole rather than a hammer drill in order to avoid breaking out the back of the hole
when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined load of the equipment and
all attached hardware and components.
20-07-197 933CC6.indb 5 20-07-197 933CC6.indb 5
W-B
Find and mark Drill pilot holes
the exact location
of mounting
holes
WARNING
5
2.6" (65 mm) 2.6" (65 mm)
W-C W-A
Ø 3/8" Ø 3/8"
(Ø 10 mm) (Ø 10 mm)
Screw the wall
mount onto the
wall
10/12/2020 1:41:06 PM 10/12/2020 1:41:06 PM