Baby Art WINDOW SCULPTURE FRAME Manual Del Usuario página 2

BABY ART WINDOW SCULPTURE FRAME
Content of the pack:
- 1 pack of dough
- 1 step 2 pack
- 1 frame
- 1 wooden roller
• STEP 1 : Prepare a at work surface
• STEP 2 : Make sure your hands
are clean and dry before starting
Knead the dough for 30 seconds and make sure
there are no air bubbles in it. Roll out the dough
until a at round surface 0.5cm (1/4 inch) thick is obtained.
• STEP 3 : Make sure the baby's hand
or foot is clean and dry before starting.
Apply gently until an imprint appears
(about 5 seconds) * If you do not like
the result, start again from Step 2.
• STEP 4 : Pour about 100ml (1/2 cup) of water
(Temp approx. 20°C/68°F) in a soft plastic container.
Add all of the step 2 packet while mixing vigorously.
Continue until a homogeneous liquid is obtained.
• STEP 5 : Fill the imprint mould obtained (Steps 2/3)
with the mix (Step 4) until it is half full.
Tap the sides of the mould to rid it of air bubbles.
• STEP 6 : Fill the imprint mould completely
making sure it does not over ow.
Tap the sides of the mould to rid it of air bubbles.
• STEP 7 : Leave to dry at room temperature for about 3 hours
• STEP 8 : Delicately remove the imprint
Cast from the mould.
• STEP 9 : Place the double-sided adhesive tape on the imprint
Place the imprint in the frame.
Personalize your baby art ! Check out our website for tips and inspiration
and share your artwork at www.baby-art.com !
This product has been assessed for toxicological and dermatological
safety according to Regulation (EC) 1223/2009 to ensure safety
equal to that required by cosmetics regulation. It can be safely used
for baby's skin.
2
NOTICE WINDOW SCULPTURE FRAME.indd 2
www.baby-art.com
19/06/13 15:31