Switching On And Off; Cutting Techniques - Hilti HURON DSH 600-22 Manual De Instrucciones

5. Tighten the nut hand-tight.
6. Return the blade guard to the closed position.
7. Connect an industrial vacuum cleaner suitable for the application to the dust extraction module.
5.7.2 Removing dust extraction module (accessory)
1. Move the blade guard until the installation position of the dust extraction module is freely accessible.
2. Slacken the nut on the dust extraction module.
3. Disengage the dust extraction module from the blade guard.
4. Return the blade guard to the closed position.
6 Operation
6.1

Switching on and off

The cut-off saw has a transport lock. The transport lock prevents inadvertent starting of the cut-off
saw when it is carried with the batteries still inserted.
Comply with the instructions for use of the transport lock in the section headed Transport lock of the
cut-off saw
1. Hold the cut-off saw by the grips provided for the purpose.
2. Press and hold down the safety switch.
3. Press the control switch.
▶ The cut-off saw runs.
4. To switch the cut-off saw off, release the control switch and the safety switch.
6.2

Cutting techniques

There is a risk of kickback if the cut-off saw comes into contact with the working surface in the area indicated.
Kickback is the result of product misuse and/or incorrect operating procedures or conditions. To prevent
kickback, follow the safety instructions and the instructions for use below.
*2284138*
2284138 English 13