1. The eSATA interface connections on the ST5610-4S-SB2 model require to
be connected to eSATA ports with port multiplication functionality in order
for all 4 drives to be recognized by your computer system. If you require
the hot swap functionality, it is important to know whether the host adapter
you'll be using supports the hot swap functionality. See Section 7 "SATA
Port Multiplication Overview" for more info.
2. The default of ST5610 Series function is Independent of storage system.
Therefore,each drive installed will be seen as separate volumes by your
computer. Also note that the actual storage capacities may differ from the
stated capacities on the hard drives once the drives have been formatted.
6. System Temperature Overheat and Fan Failure Management
If the rear alarm indicator has lit up red and the audio alarm sounds, this could mean that
either a system fan has stopped operating entirely or the system temperature has exceeded
over the default temperature of 60˚C. When this occurs, you may press the mute button at
the rear of the system to shut off the audio alarm and power off the system immediately if
in the allowed operational state then re-power on the system to double check and see if the
problem is still present. If the problem persists, please turn off the system and contact your
supplier or the STARDOM tech support for further assistance.
7. SATA Port Multiplication Overview
The ST5610-4S-SB2 utilizes the SATA port multiplication function where storage read/
write of data to multiple hard drives can be performed through one single eSATA interface
connection rather than multiple. In other words, once you've connected the ST5610-4S-
SB2 using the eSATA interface connection to the computer system, all hard drives installed
would appear on the operating system for storage purposes. However, this would mean the
eSATA host connectivity in the computer system will also require to being equipped with the
port multiplication function. Normally, if your computer system is not equipped with such,
you are required to purchase an eSATA expansion adapter card with the port multiplier
function available. You may check with your supplier of the ST5610-4S-SB2 or various
computer storage component resellers to purchase an adapter card. If you have any
questions about purchasing, please log on to www.stardom.com.tw for more information
or contact STARDOM support.
8. Introduction of the STARDOM Host Adapters
If you require a host adapter to be used with this system, please log
onto www.stardom.com.tw to find the recommended adapter or contact
STARDOM for more information.
STARDOM SOHOTANK Series User Manual
NOTE :
English
Deutsch
Français
Español
中文
日本語
한국어
7