Hardware Installation - Teltonika TCR100 Guia De Inicio Rapido

HARDWARE INSTALLATION

1. Pull out the SIM needle from SIM holder kit.
2. Push the SIM holder kit button with the SIM needle.
3. Pull out the SIM holder.
4. Insert your SIM card into the SIM holder.
5. Slide the SIM holder back into the router.
6. You may store the SIM needle in the designated
holder for future use.
7. Attach all antennas.
8. Connect the power adapter to the 4 pin socket
and then plug the other end of the power adapter
into a power outlet.
9. Connect to the device's WiFi interface by using SSID
and password or scaning QR code provided on the
device information label or use an Ethernet cable
connected to LAN port.
Power / Red wire
Not connected
6
5
POWER SOCKET PINOUT
WiFi button – Enables/Disables WiFi radio.
WPS button – Activates WPS authentication for 120
seconds.
Ground / Black wire
Not connected
NETWORK STATUS ICONS
Buttons
WiFi indication LED.
When LED is lit – WiFi is enabled.
Internet connection LED.
When LED is lit – the router has an internet
connection, when LED is blinking – internet
connection has been lost.
Mobile signal strength LEDs.
Signal strength indicated by number of lit bars.
Network status icons