Old Appliances; Before Use; Installation And Start-Up - Tecfrigo VT Manual Del Usuario

WARNING
As the appliance contain a refrigerant which are flammable it is essential to ensure that the refrigerant
pipes are not damaged.
- Keep clear of obstruction all ventilation openings in the appliance enclosure or in the structure for
building-in.
- Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
- Do not damage the refrigerant circuit.
- Do not use electrical appliance inside the food storage compartments of the appliance, unless they are
of the type recommended by the manufacturer.
This appliance is not intended for use by young children or infirm persons unless they have been
adequately supervised by a responsible person to ensure that they can use the appliance safely. Young
children should be supervised to ensure that they do not play wiht the appliance. Keep always the keys
in seperate place and out of reach of children. Never place containers with liquids, especially fizzy
,
drinks in the freezer The liquid may cause an explosion during the freezing process. Never touch the
refrigerating surfaces with bare hands. Always wear gloves to prevent burning.

OLD APPLIANCES

Old refrigerators and freezers are often fitted with complicated latches that can only be opened from the
outside. If you have one of these old units stored away somewhere, or if you scrap one, remember
to destroy the latch first in order to prevent children from being exposed to great danger by getting
locked inside the unit.

BEFORE USE

Before operating your new appliance,please read the following instructions carefully as they contain
important information on safety, installation, operation and maintenance. Keep the instructions for
future reference. On receipt, check to ensure that the appliance has not been damaged. Transport
damage should be reported to the local distributor before the appliance is put to use. Remove the
packaging. Clean the inside of the appliance using warm water with a mild, perfume-free detergent.
Rinse with clean water and dry thoroughly (see cleaning instructions). Use a soft cloth. If the appliance
has been stored in cold surroundings (colder than +5°C), it must be allowed to stabilise for at least an
hour before being switched on.
ELECTRONIC CONTROL PANEL
DEFROST WATER DRAIN

INSTALLATION AND START-UP

Placement
For safety and operational reasons, the
appliance must not be installed outdoors. The appliance should be placed on a stable, level surface in a
dry, well-ventilated room (max. 75% relative air humidity).
COLD
MASTER
.
HANDLE
SEALING STRIP
NAMEPLATE
PARTITION/DEFROST
WATER TRAY
BASKET
VENTILATION GRILLE
WHEEL
6