VONROC PS502DC Traducción Del Manual Original página 8

EN
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. On/off switch
2. Grip
3. Dust bag
4. Sanding pad
5. Sanding paper
6. Dust extraction port
7. Rubber ring
8. Battery
9. Battery unlock button
10. Battery LED indicators button
11. Battery LED indicators
12. Charger
13. Charger LED indicators
3. ASSEMBLY
Connecting the dust bag (Fig. B)
It is highly recommended to use the machine with
the dust bag (3), ensuring optimal dust collection.
• Slide the dust bag (3) onto the dust extraction
port (6) using a slight twisting motion.
• Keep sliding in twisting motion until the dust
bag (3) is positioned slightly over the rubber
ring (7), fixing it in place.
Note: The dust bag should be emptied when the
bag is half full to maintain optimal dust collection.
Mounting and removing sanding paper (Fig. C)
• Hold the machine on its side or upside down, as
shown on Fig. C1.
• Mount sanding paper (5) with the required grain
size onto the sanding pad (4). Make sure that
the perforation in the sanding paper (5) corres-
ponds with the perforation on the sanding pad
(4), as shown on Fig. C2.
• To remove the sanding paper (5), simply pull the
sanding paper from the sanding pad (4).
8
Note: Use coarse sanding paper for sanding rough,
uneven surfaces. Use medium sanding paper for
removing the remaining scratches from the coarse
sanding paper. Use fine sanding paper for finishing
surfaces.
Before any work on the power tool, remove
the battery.
The battery must be charged before first use.
Inserting the battery into the machine (Fig. D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (8) into the base of the machine
as shown in Fig. D.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. D)
1. Push the battery unlock button (9).
2. Pull the battery out of the machine like shown
in Fig. D.
Checking the battery charging status (Fig. D)
• To check the battery charge status, push the
button (10) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means
the battery is empty and must be charged
immediately.
Charging the battery with the charger (Fig. E)
1. Take the battery (8) from the machine.
2. Turn the battery (8) to upside down position and
slide it onto the charger (12) as shown in Fig. E.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (13) will lighten up and show the charger
status.
WWW.VONROC.COM