Faro GAGE Guia De Inicio Rapido De La Computadora Y El Software página 20

After setting the base face, place the FARO Gage probe on your part. Look
at the screen to see the height from the base face to the surface. Touch the
3D tab to see a three dimensional height from each base face.
• Press the Green button to freeze the Height display.
• The 3D Caliper automatically compensates for the radius of the
probe. Touch either radio button to manually compensate.
Note: If the Height is incorrect (higher or lower) by the diameter of the
probe, select a manual compensation setting.
• Press the Green button again to unfreeze the Height display and
continue.
Gage mode
P e-10
age