Publicidad
The big nozzle is useful when cleaning corners.
To attach connect the wider end of the nozzle to the steam outlet in such a way that the safety clip clicks into place. (3B)
F. Extension hose
If the surface you are trying to clean in hard to reach please use the extension hose.
To attach connect the wider end of the hose to the steam outlet in such a way that the safety clip clicks into place.
G, H. Nylon and stainless brush
Insert the big nozzle (E) into the notch of the round brush (3D), and turn it clockwise until it clicks (3D). After use, take out the round brush
by turn it anti-clockwise.
K. Extension tube x 3
If the cleaning area is hard to reach or the cleaner is used to clean floors or glass in high places, it can be used with an extension tube.
The operation method as follows: connect the end of the extension tube to the steam outlet until the fixed lock is fully buckled into the hole
of the extension tube (like in Big nozzle 3B), and locked in place with the sound of clicking means installation is complete. Please note that
using the extension tube will lower the temperature of the steam. Depending on the temperature of the tube the steam coming from the
nozzle can vary.
I. Floor brush
When cleaning the floor please use the floor brush.
Connect two or three extension tuber (K) together to the device. The other end of the extension tubes please attach to the floor brush. On
the sides of the brush press the buttons to open the fastening clamps, insert the floor towel (L) into the opened clamps. After use remove
the towel and dry / wash before next use.
Cleaning:
1. Before cleaning, pull the mains plug out of the socket.
2. Let the steam cleaner cool off before storage.
3. Wipe the steam cleaner and the accessories with a damp cloth. Let all the parts completely.
Storage:
All parts must be completely dry before storage.
- Always store the steam cleaner in a dry, clean, and dust-free place.
- Store the steam cleaner under lock, place it so that the device is not accessible for children.
Troubleshooting
Problem:
No steam coming out of the nozzle
Cause: Plug not inserted into the mains socket
Solution: Plug the device into the socket
Cause: No water in the tank
Solution: Add water into the tank.
Cause: Steam button not pressed
Solution: Release child lock and press the steam button.
Problem:
Only the green light is on. The red light does not turn on.
Cause: Light broken
Solution: Consult central service.
Problem:
The red light always on, the green light does not turn on.
Cause: Inner electric parts are broken or thermostat broken
Solution: Consult central service.
Problem:
Flickering red light
Cause: Lack of water or poor connection to mains power.
Solution: Check if the device is plugged in correctly and fully connected to the mains power. Add water. If the flickering persists please
contact the central service.
Problem:
Water flowing from the nozzle
Cause: Not used for a long while and the steam in the nozzle/accessories condensates.
Solution: Normal phenomenon. Press the steam release button for 2 seconds.
If the device still spews water from the nozzle too much water in the device.
If after longer use still water flowing from nozzle please contact central service.
Other problems:
Steam coming out of the device from places other than the steam nozzle.
Plastic deformation or softening.
After the device is empty or the steam has been released still unable to open the Safety cap (1)
Solution: Contact central service.
Technical data:
Voltage: 220-240V~ 50/60 Hz Capacity: 400 ml
Power: 1200 W
Maximum power: 2000 W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
7
Publicidad
