DHC BT300 Instrucciones Funcionadas página 2

IMPORTANT :
1. For testing 12 volts batteries with capacity range:
SAE (CCA) : 40~1200 CCA
DIN : 20~670 CCA
EN : 35~1125 CCA
CA (MCA) : 70~1440 CA (MCA)
2. Suggested operation range 32 (0 ) to 122 (50 ) in ambient temperature.
WARNING :
WARNING: This product can expose you to chemicals including arsenic, which is known to
the State of California to cause cancer. For more information, go to
1. Working in the vicinity of a lead acid battery is dangerous. Batteries generate
explosive gases during normal battery operation. For this reason, it is of utmost
importance, if you have any doubt, that each time before using your tester, you read
these instructions very carefully.
2. To reduce risk of battery explosion, follow these instructions and those published by
the battery manufacturer and manufacturer of any equipment you intend to use in
the vicinity of the battery. Observe cautionary markings on these items.
3. Do not expose the tester to rain or snow.
PERSONAL SAFETY PRECAUTION:
1. Someone should be within range of your voice or close enough to come to your aid
when you work near a lead acid battery.
2. Have plenty of fresh water and soap nearby in case battery acid contacts skin,
clothing or eyes.
3. Wear safety glasses and protective clothing.
4. If battery acid contacts skin or clothing, wash immediately with soap and water. If
acid enters eye, immediately flood eye with running cold water for at least ten
minutes and get medical attention immediately.
5. NEVER smoke or allow a spark or flame in vicinity of battery or engine.
6. Be extra cautious to reduce risk of dropping a metal tool onto the battery. It could
spark or short-circuit the battery or other electrical parts and could cause an
explosion.
7. Remove personal metal items such as rings, bracelets, necklaces and watches when
working with a lead acid battery. It can produce a short circuit current high enough to
- GB.2-V1 -
2
www.P65Warnings.ca.gov