Charging The Battery; Troubleshooting - Dynex DX-DA100501 Manual Del Usuario

All manuals and user guides at all-guides.com
DX-DA100501 English - combined.fm Page 14 Monday, August 7, 2006 12:25 PM
14

Charging the battery

Charging begins as soon as the battery is properly connected. The green charging
status indicator blinks as the battery is being charged. When the battery is fully
charged, the green charging status indicator stops blinking and stays on. You can
remove the battery for use when this happens, but we recommended that you
leave the battery on the charger for another 30 minutes to ensure a full (topped
off) charge.
A
BNORMAL BATTERY DETECTION
Your charger detects an abnormal battery pack by sensing the voltage. If it is too
high or too low, or if the battery pack does not reach full charge status within 8
hours of charging, the charger stops the operation immediately and indicate the
abnormal condition by flashing both the power and battery status indicator LEDs.
Normal operation resumes when the faulty battery is removed.

Troubleshooting

Problem
No indicator lights
Power light only
Power and battery status LEDs both blinking Defective battery*
Hissing noise while charging
* To determine if the battery is overcharged or defective, place it on the camcorder or digital camera and turn it
on. If the camcorder or digital camera does not turn on, the battery is probably defective. If the camcorder or
digital camera does not operate, leave the power turned on for 30+ minutes, then remove the battery and put it
on the charger. The charger should go into charge mode, indicated by the green blinking charge status indicator.
Troubleshooting
Possible causes and solutions
• Confirm that the AC Adapter is firmly connected at
both ends (wall and power input jack)
• Confirm that the power outlet is functioning normally
• Confirm that the car cord is firmly connected at both
ends (cigarette lighter socket and power input jack)
• Confirm that the cigarette lighter socket is
functioning normally
• The battery is fully charged *
• The battery is mounted incorrectly, remove and
remount the battery
• Clean the battery and charger contacts
• The battery may be defective*
Normal operation due to advance switching
circuitry