Error Codes - FEZIBO Eco-2 Manual De Operaciones

Error codes

System Protection
Description
Error codes will be displayed in the following scenarios:
Description
In the event of a power spike (over 8 amps) to the motor, please perform a reset.
In the event of a thermal or excessive use warning, please wait around 15 minutes for the handset to cool down, be
come operational again and displays your desk's height.
Reset Abnormality Warning
Description
In some rare cases the abnormal signal warning "FOI" may appear causing the system to enter into protection mode.
To resolve this please check cable connections and perform a reset.
Operation
Press and simultaneously for 5 seconds until the display shows''RST". Release and press down
simultaneously again, and the desk will lower and perform a reset, signaled by the display finally showing numbers .
18
overcurrent protection for motor: in the event of a power spike
(over 8 amps) to the motor, the display will show "F-01" and
the motor will cease.
thermal protection for the handset: the display will show
"HOT" on your display, when the internal temperature of the
controller is close to or above 167°F, the system enters into
an overheating protection mode during which button functions
will be disabled.
excessive use: the display will show "HOT" on your display,
activated when the height of the desk has been adjusted for
over 2 minutes continuously within a 20 minute period and
button functions will be disabled.
and