LD Systems DSP 44 K Manual De Usuario página 10

Amp Preset - Save Amp Preset
Up to 80 presets are available for internal storage of individual settings in menu items 1–7 and 9. Only menu item 8 Input Signal (analogue
/ Dante, DSP44K only) cannot be saved as an amp preset. Here the setting has to made separately. Make the settings in menu items 1 to 7
and 9 as required then select the menu item Save Amp Preset in the advanced menu and select an empty preset (Empty) by turning the
dial. Confirm by pressing the dial and enter the characters for the preset name one by one by repeated turning and pressing of the dial (15
characters maximum). To save the preset, press the SELECT / MUTE button D. In order to return to the main display, briefly press the EXIT
/ LOCK button twice.
Amp Preset - Factory Settings
To return the amp to its factory settings, select the menu item Factory Settings, press the MENU dial, turn the dial to select "Yes" in the
following dialogue and confirm by pressing the dial. Speaker presets in the LD SYSTEMS library are preserved, password request is set to
disabled and the password is reset to 0000
(four zeros).
Amp Setup - Name
To give the amp an individual name, select the menu item Name, press the MENU dial and enter the characters of the name one by one by
repeated turning and pressing of the dial (10 characters maximum). When the tenth character has been entered, press the dial once again
to confirm entry.
Amp Setup - IP address
To manually assign an IP address to the amp, select the menu item IP and press the MENU dial. Now the number can be entered for the
first of four number blocks by turning the dial. Confirm entry by pressing the dial, then the number for the second block can be entered.
Proceed in the same way to enter the numbers for blocks three and four.
Amp Setup - Password
In order to protect the amp from unwanted and unauthorised access, the password request can be enabled and a 4-digit number can be set
as the password. Select the menu item Password, press the MENU dial, turn the dial to select "enable" and confirm by pressing the dial.
Now the number can be entered for the first digit by turning the dial. Press the dial to confirm this entry and then set the
second digit. Proceed in the same way to enter the numbers for digits three and four. Password entry is
now requested before it is possible to access the amp menu. To disable the password request, select "disable" and confirm by
pressing the dial.
Amp Temperature
The temperature of the individual amp channels can be viewed as a percentage under the menu item Amp Temperature. Select the menu
item Amp Temperature and press the MENU dial (0% = low temperature, no danger to the system, 100% = high temperature, the PMS
(Power Management System) takes over control and regulates the power supply). In order to return to the main display, briefly press the
EXIT / LOCK button twice.
10