Overmax X-Hooligan Manual De Usuario página 14

collection. The product must not be disposed of together with domestic waste
as it may pose a threat to the environment and human health. The worn-out
product must be handed over to the electrics and electronics recycling center.
EN
Description of the content
1.
Controller
2.
USB power cable
3.
Storage battery x2
4.
Operating manual
How to install batteries in the controller
(fig. 1)
1.
Remove the battery cover.
2.
Insert three AAA alkaline batteries. Pay attention to polarity of the
battery.
3.
Close the battery cover.
The LED light in the controller properly paired with the device will glow in red.
If the LED light flashes in red, it means a low battery of the controller, wrong
installation of the battery, or attempt to pair with the car. Make sure the car
is active.
If the LED light does not glow at all, check battery polarization in the controller
and battery level.
NOTE! If the LED light shows a low battery, stop using the device due to
potential signal loss.
How to charge the storage battery (fig. 2)
1.
The set contains a USB charging cable.
2.
Before charging, take the storage battery out of the device.
3.
Connect the battery plug to the USB cable.
4.
Charging takes about 120 minutes. The LED light on the charger glows
in red. A flashing LED light means that the storage battery has not been
connected or has been improperly connected.