Tabla de contenido
Publicidad
Enlaces rápidos
Publicidad
Tabla de contenido
Manuales relacionados para Landa VHP2-1500
Resumen de contenidos para Landa VHP2-1500
- Página 1 All manuals and user guides at all-guides.com OPERATOR’S MANUAL vhp2-1500 (1.109-556.0) vhp3-2000 (1.109-557.0) ■ ■ use vapor fuel only 89139490-1 ® For technical assistance or the Landa Dealer nearest you, consult our web page at www.landa.com 8.913-949.0...
-
Página 2: Tabla De Contenido
The model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep in a safe place for future reference. LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 3: Introduction & Important Safety Information
CloThIng Eye, hand, and foot protection When operaTIng phase this product should only be connected to a must be worn when using this ThIs equIpmenT. power supply receptacle protected by a GFCI. equipment. LANDA VHP • 8.913-949.0 • Rev. 5/13... - Página 4 Do not use liquid fuel. Have a qualified rIsk of InJeCTIon stream at people, or severe in- or severe InJury serviceman install and service your equipment. To persons. keep jury or death will result. Clear of nozzle. LANDA VHP • 8.913-949.0 • Rev. 5/13...
- Página 5 WARNING: If connection is made to portable water supply, a back flow device must be provided. Follow the maintenance instructions speci- fied in the manual. example of Down Draft Diverter for gas fired machines LANDA VHP • 8.913-949.0 • Rev. 5/13...
-
Página 6: Component Identification
(not included) Wand rest propane hose lp Tank (not included) brass soap nozzle gfCI lp shelf Trigger nozzle quick 89139490-2 Coupler variable pressure spray gun Control handle variable high pressure pressure Wand hose LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 7: Installation
1,000 BTU input per hour. burner ring gas pressure. If you replace your gas valve, you will need to adjust the new valve. Refer to your machine’s specification plate for the correct pressure LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 8: Pre-Start Check List
1/2 psig or damage to the according to the instructions in the gas valve will occur. operator's manual? Is the incoming gas supply pressure to the machine between 6-14 water column inches or 1/2 psig? LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 9: Instructions For Lighting
4. Do not use this machine if any part has been under water. Immediately call a qualified service technician to inspect the machine and to replace any part of the control system or any gas control that has been under water. LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 10: Assembly Instructions
2: Turn all switches off. Remove and result in personal injury or property damage. position LP tank as far from machine as supply Connect water supply hose to inlet connec- hose will allow. tor and turn water on. LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 11: Operating Instructions
Look at the pilot viewing mirror at the rear of the machine. To apply detergent, read section on Deter- gents and General Cleaning Techniques. Turn gas control knob counterclockwise to “ON.” LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 12: Detergents And General Cleaning Techniques
If surface appears to be drying, simply wet down surface with fresh water. If needed, use brush to remove stubborn dirt. Rinse at high pressure from top to bottom in an even sweeping LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 13: Shutting Down And Clean Up
3. Pour about one teaspoon of engine oil through engine manufacturer's manual for service and mainte- the spark plug hole, pull the starter grip several nance of the engine. times and replace the plug. Then pull the starter LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 14: Troubleshooting
Worn crankcase piston rod seals Replace seals. rear porTIon of CrankCase louD knoCkIng Pulley loose on crankshaft Check key and tighten set screw. noIse In pump Broken or worn bearing Replace bearing. LANDA VHP • 8.913-949.0 • Rev. 5/13... - Página 15 Washer WIll Steam valve closed Open valve (counterclockwise). noT sTeam Burner not on Turn burner switch to "ON" position. Coil dirty or sooty See coil maintenance section. Steam valve clogged Clean or replace. LANDA VHP • 8.913-949.0 • Rev. 5/13...
-
Página 16: Maintenance And Service
In areas where alkaline water is an extreme The areas around the Landa washer should be kept problem, periodic use of Landa Deliming Powder (part clean and free of combustible materials, gasoline and #9-028008) will remove lime and other deposits before other flammable vapors and liquids. -
Página 17: Oil Change Record
When disk ruptures, it needs to be replaced. oIl Change reCorD no. of operaTIng no. of operaTIng DaTe oIl ChangeD hours sInCe DaTe oIl ChangeD hours sInCe monTh/Day/year lasT oIl Change monTh/Day/year lasT oIl Change LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 18: Exploded View
All manuals and user guides at all-guides.com exploDeD vIeW — lefT sIDe electronic Ignition (optional) view a-a Tank 89139490-4 (not Included, optional) LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 19: Exploded View - Right Side
All manuals and user guides at all-guides.com exploDeD vIeW — rIghT sIDe Detail see view a-a 89139490-3 LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 20: Exploded View Parts List
Swivel, 1/2" MP x 3/4" GHF w/Strainer 8.933-006.0 Switch Flow MV 60, Yellow 8.918-210.0 Hose, 3/8" x 16", 2 Wire, Pressure Loop 8.750-299.0 Unloader, VRT 3, 8 GPM @4500 PSI 8.706-168.0 Elbow, 3/8" Male Pipe LANDA VHP • 8.913-949.0 • Rev. 5/13... - Página 21 Nut, 1/4" Flange, Whiz Loc Jet Orifices 9.802-064.0 Grommet, Rubber, Nozzle Holder 9.802-463.0 Fuse, Paper, Buss FNM-1/2 250V Midget TD (Electronic Ignition Option) 8.912-890.0 Bracket, Pilot Light, VHP/VHG 8.719-957.0 Bracket, Pilot Light, VNG-S (Electric Ignition) LANDA VHP • 8.913-949.0 • Rev. 5/13...
- Página 22 8.916-090.0 Label, Landa 9.802-518.0 Strain Relief 3/4 8.706-109.0 Nipple, 3/8" x 7", Black Pipe 8.933-007.0 Fuse, KTK-R1 600V ▲ Not Shown Midget Fuse (Electronic Ignition Option) 90-19710 Screw, 1/4" x 3/4", Whiz Loc LANDA VHP • 8.913-949.0 • Rev. 5/13...
-
Página 23: Hose & Spray Gun Assembly
8.712-346.0 Nozzle, SAQCMEG 1504, 8.751-234.0 Gun, Landa, L1050, Yellow (2-1100) 5000 PSI, 10.4 GPM 8.712-358.0 Nozzle, SAQCMEG 1505.5 8.711-293.0 Wand, Only, VP, Zinc Yellow (3-700) 9.802-286.0 Brass Soap Nozzle, 1/8" ▲ Not Shown LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 24: Pump Exploded View And Parts List
See Kits Below Intermed. Ring 18mm 9.802-914.0 Snap Ring (4020, 3025) 9.803-955.0 Ball Bearing 9.802-926.0 Brass Plug 1/2" 9.803-956.0 Crankshaft 9.803-199.0 Copper Washer 1/2" 9.803-167.0 Crankshaft Key 9.803-946.0 Manifold Housing 9.803-957.0 Oil Dipstick LANDA VHP • 8.913-949.0 • Rev. 5/13... - Página 25 3, 4, 5, 34, 35, 36, 34, 35, 36, 3, 5, 7 3, 5, 7 11, 12, 13 InCluDeD 6, 7 6, 7, 37, 38 37, 38 number of CylInDers kIT WIll servICe LANDA VHP • 8.913-949.0 • Rev. 5/13...
-
Página 26: Vrt 3 Unloader Exploded Views And Parts List
If “spike” pressure exceeds the 500 psi limit, remove the adjusting knob (Item 18) and re-adjust (lower) the nuts (Items 15) on the stem (Item 8). Re-attach the adjusting knob (Item 18), then repeat step #6. LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 27: Injector Assemblies
3-700, 3-1100, 3-2000 ITem parT no. DesCrIpTIon 9.802-215.0 Injector, Detergent, Non Adjust, #2, 2-3 GPM 6.390-126.0 Clamp, Hose, .46-, .54 ST 4-02080000 Tube, 1/4" x 1/2", Clear Vinyl 6 ft. 8.707-057.0 Strainer, 1/4", Hose Barb LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 28: Warranty
Authorized LANDA Dealer of the defect. Your Authorized LANDA Dealer will file a claim with Landa, who must subsequently verify the defect. In most cases, the part must be returned to LANDA freight prepaid with the claim. For warranty service on components warranted by other manufacturer’s, your Authorized LANDA Dealer can help you obtain warranty service through these manufacturers’... -
Página 29: Introduccion & Seguridad De La Maquina
Landa. 4. Aparatos de encendido con La información de advertencia debe ser enfatizada y petróleo deberán de ser in- comprendida. - Página 30 5 minutos. 14. Nunca operar la máquina con el tanque de propano líquido colocado en el soporte. Retirar el tanque de propano líquido de la máquina tan lejos como lo permita la manguera. LANDA VHP • 8.913-949.0 • Rev. 5/13...
-
Página 31: Instalacion
Si se detectan fugas, hacer las reparaciones necesarias y repetir la prueba anterior. Cuando la lavadora a presión es instalada en un espacio muy estrecho sin aberturas de ventilación al exterior, deben tomarse medidas para suministrar LANDA VHP • 8.913-949.0 • Rev. 5/13... -
Página 32: Condensación En Los Serpentines
1. El equipo tiene un piloto que puede ser encendido en forma manual. Al encender el piloto, seguir éstas instruc- ciones en forma estricta. LANDA VHP • 8.913-949.0 • Rev. 5/13... - Página 33 “ENCENDIDO.” boquilla de bronce para Jabón boquilla de alta presión manija de Control gatillo de presión variable LANDA VHP • 8.913-949.0 • Rev. 5/13...
-
Página 34: Mantenimiento Y Servicio
En áreas donde el agua alcalina es un problema, manera. el uso regular de Polvo eliminador de cal Landa (parte manTenImIenTo y servICIo #9-028008) limpiará la cal y otros sedimentos antes que obstruyan el serpentín. -
Página 35: Capacidad Del Cilindro De Gas Propano
El conjunto de inyectores para productos detergentes flujo de aire y afectar la combustión del quemador. de Landa se puede utilizar para hacer sifón y mezclar Cuando se observe hollín, debe limpiarse después de los detergentes. -
Página 36: Identificacion De Componentes
Jabón Tanque de gas propano (no se incluye) gfCI manguera de alta gatillo presión pistola de boquilla de alta rociado presión manija de Control de presión variable varilla de presión variable LANDA VHP • 8.913-949.0 • Rev. 5/13... - Página 37 A pesar de no ser necesario para el servicio de garantía, le solicitamos que registre su unidad para el lavado a presión. Para ello, llene la tarjeta de registro y envíela a vuelta de correo. Para obtener el servicio de LANDA de la garantía, debe hacer llegar el producto a un Distribuidor de LANDA autorizado, con flete prepago, acompañado del comprobante de la...
- Página 38 All manuals and user guides at all-guides.com Form #8.913-949.0 • Revised 5/13 • Printed in U.S.A.