Rupes DD120LT Manual De Uso página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
SPECIFICATION
Battery
Rating Voltage
Battery Charger
Max Torque
Torque Settings
No-load speed
Noise
Shake
Max Capacity
Includes:
- 1 cordless drill
- 1 double Bit
- 2 battery packs
- 1 charger
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one tool
with another.
1. DESCRIPTION
1. Keyless chuck
2. Torque Adjustment
3. Forward/reverse
4. Switch trigger
5. Battery pack
6. Battery release button
7. Power LED
8. Battery charge-control LED indication
9. Mechanical gear Selection
2
1
7
4
5
2.
SAFETY
PREVENTION OF ACCIDENTE
Before operating the machine, please read
through the operating instructions completely,
follow the Safety Instructions in this manual as
well as the generai Safety Instructions for Power
Tools in the accompanying booklet.
2.1. WARNING
For you own safety, do not attempt to use your
drill until the battery is fully charged and you
6
3,6 V 1,3Ah Li-ion
30 min.
0~350rpm/ 0~1200rpm
≤75dB
≤2,5m/s
10mm Keyless Chuck
9
3
8
6
INSTRUCTIONS
English
have read all instructions:Remember the drill is
always in an operating condition as does not
12V
need to be connected to a power supply. When
not in use, place the forward/ reverse switch in
25Nm
the neutral position.Before drilling check that
17+1
there are not electrical cables, water or gas pipes
running below the surface-use a metal / voltage
detector. Do not expose either the drill or charger
2
to rain or water. Do not overcharge the battery as
this could damage the battery cells.
2.2. SECURE WORK
Use clamps or a vice to hold the work. It is safer
than using your hand and it frees both hands to
operate the tool.
2.3. AVOID UNINTENTIONAL STARTING
Do not carry the tool with a finger on the switch.
2.4. ADDED SAFETY INSTRUCTIONS FOR
CORDLESS POWER TOOLS
Safety is a combination of operator common
sense and alertness at all time when the tools
are being used.
2.5. DISPOSAL OF BATTERY
Ensure battery is disposed of safely as instructed
by the manufacturer.
2.6. HEALTH AND SAFETY FOR BATTERIES
General: do not put in fire, or mutilate cells may
burst or release toxic materials. Do not short
circuit cells as this may cause burns.
2.7. MAINTENANCE
Either the drill or the charger require any special
maintenance. Keep both the drill and the charger
in a dry place where they will not be expose for
frost of direct sunlight. Before any work on the
machine itself (e. g. maintenance, tool change,
etc.) as well as during transport and storage,
remove the battery pack from the power tool.
There is danger of injury when unintentionally
AND
actuating the On/Off switch.
3. OPERATING THE TOOLS
Battery charger (see Pic. A)
Use only the battery chargers supplied with the
tool. Only these battery chargers are matched to
the lithium ion battery of your power tool.
You tool is delivered only partly charged and
must be fully charged before use.
Take off the battery pack from the tool and
assemble the battery pack into the charger, then

Publicidad

Tabla de contenido
loading

Productos relacionados para Rupes DD120LT

Tabla de contenido