Hapro Seecret C25 Instrucciones Originales página 4

5 Put on the protective goggles provided.
6 Position yourself in front of the appliance.
Check the distance between your body and the appliance.
7
- The distance between your face and the lamps should be 10 cm. (Fig. 3)
8 Switch on the appliance by setting the timer to the required session time (Fig. 2).
- When the set time has elapsed, the timer automatically switches off the appliance.
9 Always unplug the appliance after use.
Session
As with all safe and painless skin stimulation methods, a single session will not immediately
improve the skin. Aging of the skin is a process that takes place over many years, so it should
be no surprise that it cannot be reversed with just one session lasting several minutes. To
achieve the desired effects and see visible results a series of rejuvenation sessions is required.
We recommend that you indulge in 2-3 rejuvenation sessions per week over a period of 10 to
12 weeks. Keep in mind that a 48-hour rest period is required before you begin the next
session.
The results will be measurable after about one month, and you will see visible results after
about three months. This differs from person to person, however, and depends greatly on the
skin. After three months it may be assumed that the condition of your skin has reached a level
at which the frequency of the sessions can be reduced. You can then switch to 'maintenance
sessions' , once every two weeks.
Session time
30 minutes
● A course of treatment during a continuous 10 to 12 week period
● 2 to 3 sessions per week
● Rest period of 48 hours between sessions
● A maintenance session once every two weeks, after completing a course of treatment
As far as is known, from a scientific perspective, there is no need to limit the number of
treatments with collagen light. However, based on careful study and practical tests, VDL Hapro
B.V. has established these usage recommendations to help you achieve the most optimal
results.
Protective goggles
The protective goggles should only be used with a Hapro Seecret appliance. They should not
be used for other purposes.
The protective goggles comply with protection class II according to directive 89/686/EEC.
1
Number of sessions per week
2-3
2
Number of weeks
10-12
- 4 -
3 4