Oven Light Replacement - amzchef AT7010S08 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

①Open the door to the maximum angle and pull the lock
back at the hinge of the door(Figure 1). There are two
locks on both sides of the oven door.
②Close the oven door, at about 15 degree, then lift the
door, and slowly pull out from the oven.(Figure 2)
③After cleaning, perform the above-mentioned operations
in the opposite steps to restore the door to its original condition.
■Note: After using a specific detergent, run the oven for 15-20
minutes with maximum heating settings to remove residues in the oven.
In this process, touchable parts may be hotter than usual. Keep
children away from the oven.
Remove the hanger to facilitate cleaning the side wall of the oven. Note: Operate this process must by hand
slightly, or it will damage the enamel.
• Remove all accessories such as grate and baking tray.
• Slightly push down the hook in racks at the clamping point as shown (A).
• Swivel the rack inwards to an angle of approx. 45 degrees(B-C).
• Unhook it at the top and carefully pull it out (C).
• To re-install after cleaning, follow the steps above in reverse order.
The light used in oven is a special high temperature
resistant light (AC220V/25W).
Therefore, it is necessary to purchase genuine light from
authorized distributors.
The replacement steps are as follows:
1.Disconnect the power supply of the power socket.
Remove the Slide-in racks

Oven Light Replacement

17

Publicidad

Tabla de contenido
loading

Tabla de contenido