Troubleshooting; Faqs And Troubleshooting; Installation Instructions - amzchef AT7010S08 Manual De Instrucciones

Troubleshooting

Warranty & Service

FAQs and Troubleshooting

On no account open the appliance housing!
Installation, maintenance and repairs may only be carried out by a suitably qualified and competent person in strict
accordance with current national and local safety regulations.
Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for
unauthorised work. Ensure current is not supplied until after maintenance or repair work has been carried out.
Problem
The oven does not heat up
A noise can be heard after a
cooking programme
The lighting is not working
Cakes and biscuits are
browning unevenly

Installation Instructions

●
The kitchen cover must be suitable to ensure that the oven works properly.
●
The panel of kitchen equipment adjacent to the oven must be made of heat-resistant materials. Kitchen
equipment made of plywood shall ensure that the glue can withstand a temperature of at least 120 degrees
Celsius. When plastic or glue cannot withstand this temperature, the equipment will melt and deform.
●
Once the oven is placed in the kitchen equipment, the electrical components must be completely insulated. This
is a
statutory safety requirement.
Possible cause and remedy
- The oven may not be switched on. Switch the oven on.
- The clock may not be set. Set the clock.
- Check to see if the required settings have been applied.
- A household fuse may have blown or a circuit breaker may have
tripped. Replace the fuses or
reset the circuit. If this happens repeatedly, call an authorised
electrician.
The cooling fan remains switched on after the end of a cooking
programme.
- Disconnect the appliance from the electricity supply:
Switch off and unplug at the socket, or disconnect the fuse, or switch
off at the isolator as appropriate.
- Turn the glass cover counterclockwise.
- Remove the light and replace it with the same type.
- After replacing the light, screw the glass cover clockwise.
There will always be a slight unevenness. If browning is very uneven
check that the correct
temperature was set and that the correct shelf level was used.
Important note
19