Tabla de contenido
Publicidad
distance from the machine (for models
with side discharge function only).
F.
Grass catcher: in addition to collecting
the mown grass, the grass catcher also
constitutes a safety element, since it
prevents any objects picked up by the
cutting means from being projected
long distance from the machine (for
models with rear collector only).
G. Discharge chute: this is the part
connecting the cutting means
assembly to the grass catcher (for
models with rear collector only).
H. Driving seat: this is where the
machine operator sits. It has a sensor
connected to safety devices for detecting
the presence of the operator.
I.
Steering wheel: turns the front wheels.
J.
Front bumper: this protects the
front section of the machine.
K. Battery: provides the energy for starting the
engine. Its specifications and regulations
for use are described in a specific manual.
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the indications provided in the
"ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging holds the components needed
for assembly as listed in the table below:
Description
1
Steering wheel
2
Dashboard cover and steering
wheel assembly parts
3
Driving seat
4
Front bumper (if fitted)
All manuals and user guides at all-guides.com
1. Carefully open the packaging, paying
2. Consult the documentation in the
3. Remove all the unassembled
4. Remove the machine from the packaging
5. Move the front drive release lever to
• Type "I" steering wheel
1. Put the machine on a flat surface
2. Using a screwdriver, remove the central cap
3. Fit the steering wheel (fig. 3.A) onto the
4. Secure the steering wheel using the screw
EN - 7
5
Bag with mounting screws etc. and
instructions TS-TX-TH models only)
(models with rear collector only)
6
Grass catcher bag supports and
associated attachments (models with
rear collector only)
7
Side discharge chute (for models with
side discharge only)
8
Cutting means assembly side
strengtheners (if fitted).
9
Envelope containing:
- the instruction manuals and documents
- driving seat assembly screws
- side discharge chute assembly fittings
(for models with side discharge only)
- the connection screws for the battery
cables
- 2 starter keys
- 1 spare 10 A fuse
10
Mulching kit (models with side discharge
function only) (if fitted).
4.1.1 Unpacking
attention not to lose components.
box, including these instructions.
parts from the box.
taking the following precautions:
– move the cutting means assembly
to its maximum height (par. 5.14) to
protect it against damage when the
machine is lifted off the base pallet;
– Lift the machine off the base pallet.
the released position (par. 5.4).
4.2 STEERING WHEEL ASSEMBLY
and straighten the front wheels.
(fig. 3.B) from the steering wheel (fig. 3.A).
protruding shaft (fig. 3.C), rotate it so that the
spokes are facing the seat and then push
it so that the steering wheel hub couples
with the protruding end of the pin (fig. 3.D).
(fig. 3.E) and the washers (fig. 3.F) e (fig.
3.G) supplied, in the indicated sequence.
Publicidad
Tabla de contenido
