Barrette rdi collection FINYL LINE Manual Del Usuario página 5

INSTALLING BRACKETS
8.
a. Make sure rails centered to post sleeve. Then,
using 1⁄
hole (Fig. 8). Drill through bracket hole, vinyl post
sleeve and vinyl insert and loosely install first #10
x 1½" screw.
b. Repeat pre-drilling process for remaining three
screws (Fig. 8).
c. Tighten screws until the bracket is snug with
the post. We recommend a non-impact drill with a
clutch setting to avoid over tightening (Fig. 9).
Repeat steps a-c for the second top bracket.
INSTALLING SIDE BRACKET SCREWS AND COVERS
9.
a. For each installed bracket, pre-drill in the center
of each elongated hole with a 1⁄
b. Install #10 x 1" screws in all pre-drilled holes
(Fig. 11).
c. Match letter on inside of bracket cover to the
letter on bracket, and snap cover in place (Fig. 12).
Repeat for all brackets.
" drill bit, pre-drill first top bracket screw
8
" drill bit (Fig. 10).
8
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
5