Descargar Imprimir esta página
Uline Н-57 Guia De Inicio Rapido
Uline Н-57 Guia De Inicio Rapido

Uline Н-57 Guia De Inicio Rapido

Tensionadoras y selladoras para fleje

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-57, H-540, H-572
H-702, H-703
STRAPPING TENSIONERS
AND SEALERS
Cutter Wheel
Windlass
PAGE 1 OF 3
1-800-295-5510
uline.com
Tension Lever
Base Handle
Gripper Plate
OPERATION
THREADING TENSIONER
1.
Wrap both ends of strapping around product.
2.
Squeeze handle and base together.
3.
Insert the shorter end of strapping under the gripper plate and cutter
wheel leaving approximately 5" of strapping off the front end.
4.
Release handle and base.
5.
Feed the other end through the cutter wheel and up through the windlass.
Figure 1
6.
Pull strapping as tight as possible.
TENSIONING
1.
Move tension lever forward and back to begin tensioning.
2. Continue back and forth motion until strapping has reached desired
tension.
PLACING THE SEAL
1.
Seal should be placed open side down on top of both ends of strapping.
SEALING
Figure 2
1.
Close nose of sealer around seal.
2. Crimp tightly around strapping.
REMOVING EXCESS
1.
Squeeze handle and base together to cut strapping.
2.
Slide tool off to the right.
MAINTENANCE
Tools do need to be cleaned and maintained periodically with a steel brush or
dry compressed air. Lubricate all moving parts with light machine oil.
Figure 3
(See Figure 1)
(See Figure 2)
(See Figure 3)
Para Español, vea página 2.
Pour le français, consulter la page 3.
0521 IH-540

Publicidad

loading

Resumen de contenidos para Uline Н-57

  • Página 1 Para Español, vea página 2. Pour le français, consulter la page 3. H-57, H-540, H-572 1-800-295-5510 H-702, H-703 uline.com STRAPPING TENSIONERS AND SEALERS Tension Lever Cutter Wheel Base Handle Gripper Plate Windlass OPERATION THREADING TENSIONER (See Figure 1) Wrap both ends of strapping around product.
  • Página 2 H-57, H-540, H-572 800-295-5510 H-702, H-703 uline.mx TENSIONADORAS Y SELLADORAS PARA FLEJE Palanca Tensionadora Rueda de corte Mango de la base Molinete Placa de agarre FUNCIONAMIENTO COLOQUE FLEJE EN TENSIONADORA (Vea Diagrama 1) Envuelva ambos extremos del fleje alrededor del producto.
  • Página 3 H-57, H-540, H-572 1-800-295-5510 H-702, H-703 uline.ca TENDEURS DE FEUILLARD ET SCELLEURS Levier de tension Roue de couteau Poignée de base Bourriquet Plateau de préhenseur FONCTIONNEMENT ENFILAGE DU SERTISSEUR (Voir Figure 1) Entourer le produit avec les deux extrémités du feuillard.

Este manual también es adecuado para:

Н-540Н-572Н-702Н-703