Rev-A-Shelf 4WV Serie Instrucciones De Instalación

2409 Plantside Dr., Jeffersontown, KY 40299
NOTE: SCREWS NOT INCLUDED DUE TO VARIANT SIZES IN CABINETS
800.626.1126
www.rev-a-shelf.com
TOOLS REQUIRED:
Part list:
1)
Measure the inside cabinet width (ICW) at desired height for wood rails.
Inside
Cabinet
Width
(ICW)
Desired Height
of Rail
4)
Cut wood rails per steps 1-3.
WOVEN BASKET INSTALLATION INSTRUCTIONS
ESTIMATED ASSEMBLY TIME:
CARE AND MAINTENANCE:
20 MIN
Clean basket and wood frame with a damp cloth and wipe parts
dry. machine wash liner in cold water with like colors.
2)
Measure the width of basket wood frame (BW).
3)
Subtract BW from ICW. Divide answer by 2. Subtract 1/16" from answer.
This will give you the dimension needed from bottom of groove to back of wood
rail (ICW-BW) ÷ 2 - 1/16".
(ICW-BW) ÷ 2 - 1/16"
Bottom of groove
5)
Place first cut rail in cabinet with front of rail against back of face frame (for
frameless cabinets, flush with front of cabinet.) at desired height. Secure the front
hole with proper size screw. (Screws not included due to variant in cabinet wall
thicknesses) (Make sure screw does not go through outside wall of cabinet).
7)
Measure from floor of cabinet to bottom of installed rail.
Basket 8)
Install second rail on opposite side of cabinet per steps 5-6 at height
Width
location from step 7.
(BW)
9)
Slide in basket.
6)
Make sure rail is level, then secure to cabinet with screws at
remaining hole locations.
Bottom of
rail to floor of
cabinet
I-4WV-TRI-1013