Reggiani KYLIOS Instrucciones Para El Instalación página 16

KYLIOS | ENG |
ACCESSORIES
The luminaire can be fitted with two types
of light source: LED and metal halide
lamps. For more information about the
light sources, refer to the catalogue or ac-
cess the product datasheet on the website:
www.reggiani.net/reference.
After installation of the projector and
before powering the system, install or
replace the reflector and light source, fol-
lowing the instructions below.
INSTALLATION/REPLACEMENT
OF REFLECTORS AND LIGHT
SOURCES
The luminaire can be fitted with two types
of light source: LED and metal halide
lamps. For more information about the
light sources, refer to the catalogue or ac-
cess the product datasheet on the website:
www.reggiani.net/codice.
www.reggiani.net
All manuals and user guides at all-guides.com
After installation of the projector and
before powering the system, install or re-
place the reflector and light source.
• For metal halide lamps:
Metal halide lamps MT/UB G8.5 – G12,
20/35/50/70W
Remove the safety reflector by turning it
A
anti-clockwise (fig.4);
insert/replace the lamp (with one of
B
equal rating as the ballast, see rating
plate);
re-engage the reflector correctly by
C
turning it clockwise.
N.B. Always check the safety glass for
intactness and for perfect fitting on the
locking ring
Warning: when the lamp is dying – i.e. the
luminous flux is decreasing – it must be
replaced to prevent serious damage to the
control gear.
Turn the electricity off at
the mains and follow the in-
structions below.
013
4
A
4
B
4
C