Leakage Test; Starting The Appliance; Use Instructions - Kemper 104998 Instrucciones Para El Montaje, El Uso Y El Mantenimiento

4. Do not move the appliance during use.
5. Never modify your hot plate and absolutely never disassemble the appliance and its components.
Reparations on the appliance must be made only by qualified personnel.
6. Never use the appliance if it leaks, is deteriorated or malfunctioning.
7. During use, always close the cartridge holder lid (D).
8. Do not let domestic animals near the hot plate.
9. Never leave the hot plate going and unguarded.
10. ATTENTION: very high temperature parts are easily accessible. Keep the appliance away from
children.
11. This appliance is equipped with a cartridge disconnection device in case of overpressure: if the gas
pressure in the cartridge exceeds the security level, the device disconnects the cartridge and its
connecting lever returns to position "UNLOCK". In this case, remove the cartridge and let it cool
(for example under water) before using it again or using a new cartridge by following instructions
mentioned on "Replacing the cartridge" section.
12. DO NOT force restarting without cooling or replacing the cartridge.
1. Use exclusively KEMPER / PLEIN AIR INTERNATIONAL butane cartridges art. 577, WOODSUN
art. 577LCL or Decathlon 4050185. It may be dangerous to adapt other gas containers.
2. All operations of assembly and change of cartridges must be done in well-aired places and far from
flames, inflammable materials and other peoples.
3. Read carefully the instructions on the wrapping of the cartridge before using.
4. Never try to refill a disposable cartridge.
5. Remove the cartridge after each use in order to avoid overheating the appliance.
6. Never expose cartridges at temperatures over 50°C.
7. Always keep the appliance away from children.
8. Never breathe in the gas coming from the cartridge or the smoke produced while using the
appliance.
9. Never smoke while handling cartridges.
IN CASE OF LEAKAGE (SMELL OF GAS) BRING YOUR APPLIANCE IMMEDIATELY OUTDOORS,
IN A VENTILATED PLACE WITH NO INFLAMABLE SOURCES, AND THERE YOU CAN LOOK FOR
LEAK AND STOP IT. IF YOU WANT TO CHECK THE Seal OF YOUR APPLIANCE, DO IT
OUTDOORS AND NEVER LOOK FOR A LEAKAGE WITH A FLAME BUT USE SOAPY WATER.
BEFORE USING CHECK THAT THERE ARE NO LEAKS. Check the leakage of your device only outside. Do
not seek the leakage with a match but use water and soap or a gas detector (our article Revelgas cod. 1726).
Apply solution of soap and water or gas detector in the interspaces of the unit. If bubbles appear, it means that
there is a leak and it must be repaired before use. If you detect a leak and you cannot repair it, don't try to fix it
another way, but contact the customer service. Do not use a device that leakage, deteriorated or malfunctioning.

STARTING THE APPLIANCE

Note: This device is intended only for direct cooking of food. It is NOT allowed to use pots.
1. Do not use the appliance other purposes than cooking.
2. Place the hot plate on a stable and horizontal surface. Do not alongside two or more burners.
3. Place the hot plate far from inflammables substances or things that could be damaged by heat.
4. Make sure that the hot plate tap is CLOSED - Tap on position "OFF" (clockwise rotation).
5. Make sure that the seals are in a good state before connecting the gas
cartridge (see figure).
6. Never use the appliance with damaged or worn seals.
7. Check that the appliance is not damaged. Never use a damaged
appliance.
8. Put the cartridge in its slot, placing the cut on its neck in correspondence
to the safety stop.
9. Place the lever connecting the cartridge on the "LOCK" position (fig. 2).
ATTENTION: the appliance is now ready for use. The positioning of the lever on "LOCK"
presupposes the immediate ignition of the stove as the gas circuit is ready for gas supply. Do not
leave the appliance unattended and without flame with the lever positioned on "LOCK".
DT Istr 104998 – 09/18_REV.4_10/20
INFORMATION ON THE USE OF CARTRIDGES

LEAKAGE TEST

USE INSTRUCTIONS

10/72
104998