Cleaning And Maintenance; Maintenance - Repair - Kemper 104998 Instrucciones Para El Montaje, El Uso Y El Mantenimiento

Fig. 1
10. Turn anticlockwise all the way the tap until it is positioned on "MAX" position; continue the rotation until
ignition occurs.
11. If the stove dose not light, turn the control knob back to "OFF" position and repeat.
12. If after three failed attempts, the stove dose not light, turn the control knob to the "OFF position and move
the cartridge lever to the "UNLOCK" position.
13. Open the cartridge cover and remove the cartridge, Shake the cartridge to see if it is empty. If empty, replace
the cartridge and repeat from point 9.
14. Regulate the flame according to your needs.
15. Caution: The device is not equipped with a security system for the automatic closing of the gas.
16. It is recommended to cook food with a thickness not exceeding 1.5-2 cm.
SHUTTING DOWN THE APPLIANCE
1. To turn off the fire, rotate completely clockwise the tap to the "OFF" position and wait until the flame is fully
extinguished before performing the next step.
2. Position the cartridge-connecting lever on the "RELEASE" position and remove the gas cartridge from the
compartment.
3. Wait for the plate to cool before storing it.
4. When the appliance is not in use, it is compulsory to take the cartridge out of the appliance.
5. This unit can be kept inside only if the cartridge has been disconnected and removed from the appliance. If
you expect that the barbeque remains unused for a certain period of time, store it in its original packaging
and in an environment free from dust.
CHANGING THE CARTRIDGE
1. Ensure that the cartridge is empty before replacing it (shake it in order to hear the sound produced by the
liquid).
2. Replace the cartridge outside and away from other people.
3. Make sure that the tap of the hot plate is CLOSED. Tap on "OFF" position (clockwise rotation).
4. Check that the cartridge connection lever is on the "RELEASE" position.
5. Open the cartridge holder lid and take out the cartridge.
6. Check that the seals are in a good state of maintenance.
Put the cartridge in its housing placing the cut on the cartridge's neck in correspondence to the safety stop.
7.

CLEANING AND MAINTENANCE

Clean your equipment after EVERY USE. Do not use abrasive or flammable detergents, which may damage the
components of the unit and may cause a fire. Clean with a solution of warm water and soap.
NEVER USE THE PRODUCTS FOR OVEN CLEANING.
CAUTION: All cleaning and maintenance operations, should be made when the unit is cold and after removing
the cartridge.
EXTERNAL SURFACE: wash with a soft cloth and a solution of warm water and soap. Rinse with water. Do not
use abrasive cleaners, degreasers or concentrated products for cleaning of barbecues.
Use a solution of gentle detergent or baking soda and hot water. In case of stubborn stains, use a non-abrasive
detergent powder and then rinse with water.
BOTTOM OF THE BARBECUE DRIP: the tray should be cleaned after each use in order to prevent that
accumulation of grease can ignite causing a flash fire. Remove residuals with a brush, a scraper and / or a
sponge and then wash with a solution of water and soap. Rinse with water and let dry.
PLASTIC SURFACES: wash with a soft cloth and a solution of warm water and soap. Rinse with water. Do not
use on plastic surfaces abrasive cleaners, degreasers or concentrated products for barbecue cleaning.
WIRE RACK: use a mild solution of soap and water. In case of stubborn stains, use a non-abrasive detergent
powder and then wash with water. Do not use abrasive cleaners or metal brushes that could damage the surface
coating of the grill.
MAINTENANCE – REPAIR
All questions of the departments services must be formulated to: KEMPER – Via Prampolini 1/Q – Lemignano
di Collecchio (PR) – Italy – Tel. +39 0521 957111 – Fax +39 0521 957195 – www.kempergroup.it
DT Istr 104998 – 09/18_REV.4_10/20
11/72
104998
Fig. 2