Sunny SF-BH6507 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
STEP 1:
Attach the Upright Bar (No. 1) to the Rear
Stabilizer (No. 2) and the Front Right
Stabilizer (No. 5) using 6 Bolts (No. 7)
and 6 Washers (No. 8). Tighten and
secure with Spanner Wrench.
Attach the Upright Bar (No. 1) to the Rear
Stabilizer (No. 2) and the Front Left
Stabilizer (No. 3) using 6 Bolts (No. 7)
and 6 Washers (No. 8). Tighten and
secure with Spanner Wrench.
Insert the Adjustment Knobs (No. 6) into
the holes located on the Front Left and
Right Stabilizers (No. 3 and No. 5).
STEP 2:
Position the Safety Connector (No. 4) so
the holes face upward. Insert one end into
either of the front stabilizers by pulling and
holding the Adjustment Knob (No. 6)
upward. Slide the Safety Connector (No.
4) inward and release the Adjustment
Knob (No. 6).
The Adjustment Knob (No. 6) will click,
indicating it has locked in place. Repeat
this process to connect the other front
stabilizer.
NOTE: The Safety Connector (No. 4)
contains multiple holes along each side
which allow you to adjust the distance
between the Upright Bars (No. 1). The
distance between the bars will determine
the difficulty and intensity of your exercise.
The assembly is complete!
4