Transportation And Storage; Cleaning And Maintenance; Scale Removal - Expondo Royal Catering RCKM-20 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
down. Once the desired amount is dispensed, release the valve. When not in use, make sure the ON/OFF
switch is in the "OFF" position. Before pouring out the remaining coffee and cleaning out the filter and
coffee grounds wait until they've cooled down. Check water level when in use - brew fresh coffee when
required. Turn the percolator off if the water level falls below the required minimum on the water level
indicator (30).
Please note! The device features overheating detector. It will activate when water evaporates or when
water level is below the allowable level and the device is still on. If this happens a protection will trip and
switch the device off. In such a case wait until the device cools down then drain water from the tank, turn
the device 180° (upside down) and press the reset button (marked as "Reset button"). Now the device can
be used again.
Do not turn the coffee maker on without water! This may damage the percolator and invalidate the gua-
rantee!
Use RCKM-FILTER-1000 filters with the coffee maker (not included).
ASSEMBLY / DISASSEMBLY OF THE DEVICE'S ELEMENTS:
Assemble all elements before turning on. Make sure the drip tray
is attached using both mounting points.
Mount the basket support tube and the filter basket inside the
tank. To do that, slide the filter basket over the support tube and
insert the tube into the opening at the bottom of the tank.
12

TRANSPORTATION AND STORAGE

Shaking, crashing and turning upside down of the device should be prevented when transporting it. Store it
in a properly ventilated location with dry air and without any corrosive gas.

CLEANING AND MAINTENANCE

Disconnect from electricity when cleaning equipment.
Use cleaner without corrosive substances to clean surface.
Dry all parts well after cleaning before the device is used again.
Store the unit in a dry, cool location, free from moisture and direct exposure to sunlight.

SCALE REMOVAL

When using hard water scale may build up in the water tank. The sediment may extend the time necessary
to heat water in the tank and lead to damage of the device. To avoid sediments in the tank use filtered water.
Descale the percolator regularly using generally available descaling substances suitable for coffee makers.
REGULAR CONTROL OF THE DEVICE
Regularly control whether the device is damaged. If it should be damaged, please stop using it immediately
and contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
Invoice number and serial number (the latter is to be found on the technical plate on the device).
If relevant, a picture of the damaged, broken or defective part.
It will be easier for your customer service clerk to determine the source of the problem if you give a
detailed and precise description of the matter. Avoid ambiguous formulations like "the device does not
heat", which may mean either that it does not heat enough or that it does not heat at all. The more
detailed your information, the better the customer service will be able to solve your problem rapidly
and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 03.11.2016
Rev. 03.11.2016
13

Publicidad

Tabla de contenido
loading

Tabla de contenido