RCA RP7994 Manual Del Usuario página 7

All manuals and user guides at all-guides.com
Using The Tape Player
Playing a Cassette Tape
1. Move the FUNCTION switch to TAPE.
2. Press STOP/EJECT to open the cassette
compartment door.
3. Insert cassette tape into the
compartment with the open edge facing
up and the full reel on the right.
4. Close the door securely.
5. Press REW or F.FWD to move tape to the
desired starting point.
6. Press PLAY to begin playing the tape.
The cassette tape plays until it reaches
the end of the side, then it
automatically stops.
Recording on Cassette Tapes
You can record from the radio or the CD
player.
For best recording, use normal bias tape.
Erase Protection
When you record new material, the
cassette deck records over whatever is on
a tape. To protect a tape from accidental
erasure, break off one or both plastic
tabs (one for each tape side) on the top
of the cassette tape. If you decide later to
record on the tape, seal the hole with a
piece of cellophane tape.
Quit Slacking
A little bit of slack in your tapes can
cause scratches on the tape, or worse
yet, the tape could break. If you
notice some slack in the tape, use a
.
pencil to tighten it up before you
insert it.
A
RP7994 EngIB
Recording from the Radio
1. Insert a cassette tape into the tape deck
and close door.
2. Move the FUNCTION switch to RADIO
and select a radio station.
3. Press RECORD to begin recording.
RECORD and PLAY lock down.
4. Press STOP/EJECT to end recording.
5. To turn off radio, move the FUNCTION
switch to TAPE.
Radio Recording TIPS
• To temporarily pause the recording,
press PAUSE on the cassette deck. Press
Pause again to resume recording.
Recording from CDS
1. Insert a cassette tape into the tape deck
and close the door.
2. Press RECORD and PAUSE at the same
time.
3. Move the FUNCTION switch to CD.
4. Insert the CD you want to record into
CD compartment.
5. To begin recording at track 1 - or press
SKIP
you want to record - press the PLAY/
PAUSE button near the Display, then
immediately release the PAUSE button
on the tape deck.
Pause for a Moment
Using the PAUSE
deck instead of the STOP button to
momentarily interrupt recording gives you
a much cleaner sounding recording.
4
or to choose the track
button on the cassette
7/12/00, 5:23 PM
EN
3