Key Automation SEL3 Instrucciones Y Advertencias Para Su Instalación Y Uso página 12

STATUS AND/OR
ERRORS
Selector connection
Selector battery low
Communication error
between the
receiver and control unit
Selector absent or not
reached
4.13 SWITCHING ON THE SELECTOR
Once connected, the Digital Selector will turn on and display the status of the automatic door.
DESCRIPTION
The blue bidirectional status LED flashes
The blue door status LED turns on
4.14 DOOR CONTROL UNIT RESET
DESCRIPTION
Press and hold the selector key for at least 10 seconds until the
door status LEDs start to turn on in clockwise order.
At the end of the operation, the selector will indicate again the active
status of the door by illuminating the corresponding led.
NOTES: the first manoeuvre after resetting the card will be performed slowly. The reset cycle lasts
approximately 10 seconds.
4.15 CHANGING THE STATUS OF THE DOOR
DESCRIPTION
Press and hold the selector key for at least 2 seconds
The door active status LED will start flashing
Press the button several times until the desired status is selected
After 2 seconds from the selection, the LED will become fixed and
the door will acquire the chosen status.
NOTES: If a Lock Delay greater than zero has been programmed and the lock status is selected, the
internal radar LED will light up and the lock status LED will flash; when the time has elapsed, the lock
status LED will become fixed and the automatic door will be locked.
YELLOW GREEN / RED
LED LED
Green Fast flash
Flashing
Green Fast flash
fast
Red Fast flash
Flashing Red every
5 sec
BEEP
a short double beep
a long beep, and if DIP3=on, a
short beep every 5 seconds
a long beep, and if DIP3=on, a
short beep every 5 seconds
a double long beep followed by 5
long beeps, every 5 seconds, and
if DIP3=on, a short beep every 5
seconds
EXAMPLE
BLUE
EXAMPLE
> 10s
BLUE
EXAMPLE
BLUE
+
BLUE
>2s
+