Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1 - SAFETY WARNINGS
WARNING - for the safety of people, it is important to observe these instructions and keep
them for future use.
Read the instructions carefully before installation. The design and manufacture of the devices which
make up the product and the information contained in this manual comply with the current safety
standards in force. However, incorrect installation and programming can cause damage to property
and injury to persons who carry out the work and those who use the system. It is, therefore, important
to carefully follow all the instructions given in this manual during installation.
2 - INTRODUCTION TO THE PRODUCT
DIGITAL RADIO SELECTOR FOR AUTOMATIC DOORS LEVANTE
The SEL3 Digital Selector is a device for radio control of automatic doors. Communication with the
CTLEV control unit takes place through the RXLEV receiver that must be inserted in the appropriate
CN9 connector. Up to four SEL3 selectors can be matched.
3 - PRELIMINARY CHECKS
WARNING - before installing the product, verify and check the following points:
• Check that the surface on which the device will be fixed is solid and does not vibrate
• Use suitable electrical connections for the current required
• Check that the power supply complies with the values of the technical specifications
• Disconnect the power supply before installing
• Make sure there is a circuit breaker in the power supply system with a distance between the contacts
that allows for total disconnection under the conditions laid down by overvoltage category III
4 - PROGRAMMING
4.1 DIGITAL SELECTOR LAYOUT
There are 8 blue LEDs that indicate the status of the automatic door, 2 red LEDs for reporting errors, a
yellow LED for signalling the low battery and a button for selecting the states and possibly for resetting
the CTLEV card.
ON
1 2 3 4
GREEN LED
RED LED
BUTTON P2
DIP-SWITCH
DIP4 is not used
YELLOW
LED
BUTTON
LEDs
RED
EN
LEDs
BLUE
YELLOW
LED
Publicidad
Tabla de contenido
