Before Use - Koshin PKG-1500 Manual De Funcionamiento

BEFORE USE

1. Check that the model type, frequency, and
voltage of the pump are correct. (Refer to
the model number plate)
2. Connect the ground wire to ground before
connecting the power plug.
To prevent ground leakage incidents, in-
stall a ground leakage circuit breaker.
3. Hold the handle when carrying the pump.
Also, when installing the pump, tie a rope
or similar line to the handle.
HOW TO USE THE PUMP
1. Submerse the pump completely in the wa-
ter.
If you lower the pump by holding the pow-
er cord or hose, the cord will be broken
and the hose will come out.
Tie a rope to the pump handle, and lower
the pump slowly into the water.
2. Do not allow the end of the delivery hose
to become submerged.
If the end of the hose is higher than the
surface of the water when the pump is
stopped, the water will flow back due to
the siphon effect.
3. Connect the power plug.
4. The pump should be installed in the posi-
tion where water accumulates most easily.
When installing on soft ground, such as
gravel or sand, position wooden boards or
blocks, etc. below the strainer to prevent
the pump from sinking.
5. When using a generator, it must have a
capacity 3–5 times of the electric power
consumption of the pump. (Read the op-
erating manual of the generator carefully
and use it correctly).
4 4