Koshin PKG-1500 Manual De Funcionamiento página 6

FAULT CHECKS
(A) Pump will not start
• Power switched ON
• Blown fuse (consult an electrician)
• If extension lead fitted check connection
• Impeller jammed
• Thermal cut out switch has not reset (5
minutes)
• If the pump does not start from new then
the seal has possibly stuck due to the
length of time that it has been standing
since it was manufactured. In this case, re-
move bottom strainer and turn the impeller
nut clockwise with a pair of pliers, this will
release the initial friction on the seal and
once the power is connected will allow the
pump to work.
(B) Pump will start but does not pump
• Insufficient liquid in sump
• Strainer blocked
• Impeller blocked
• Impeller damaged
• Entrained air present
• Excessive back pressure
(C) Pump will not stop
• Must be switched off the power supply
Do not run dry as this will damage the seal
and reduce the life of the pump.
With simple cleaning and regular examina-
tion this pump should give many years off
service.
For a full spares and repair service on any
of our pumps send pump properly packed
and post paid to your dealer.
(D)
• Do not dispose of the product as unsorted
municipal waste, use separate collection
facilities.
• Contact your local government for infor-
mation regarding the collection systems
available.
(D)
• If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get into
the food chain, damaging your health and
well-being.
(E)
• Don't used in swimming pool.
• Pollution of the liquid could occur due to
leakage of lubricants.
• Pumps for outdoor fountains, garden
ponds and similar places have to be sup-
plied through a RCD (operating current <
30 mA).
• The supply cord cannot be replaced, if
the cord is damaged, the pump should be
scrapped.
(F)
• This pump is not intended for use by per-
sons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or in-
struction concerning use of the product by
a person responsible for their safety.
• Children should be supervised to ensure
that they do not play with the pump.
• The pump must not be used when people
are staying in the water.
• The pump must supplied through a residu-
al current device (RCD) with a rated resid-
ual operating current < 30 mA.
• Pollution of the liquid could occur due to
leakage of lubricants.
6 6