Festool CS 70 ST Instrucciones De Montaje página 9

5.2 Adjusting the table height
A separate adjustment must be carried out at the
front and rear support.
• Loosen counternut (3.4)
• Set correct height and adjusting screw (3.3).
• Re-tighten counternut (3.4) and fastening bolt
(5.4).
6 Adjusting the parallelism of base and slid-
ing tables
6.1 Checking the parallelism
• Move stop guide up to saw blade. If the sliding
table is correctly adjusted the gap between the
underside of the stop and the base table is the
same across the whole width.
6.2 Adjusting the parallelism
A separate adjustment is necessary at the front
and rear supports.
• Release handle (3.1).
• Release counternut (3.8).
• Adjust parallelism of both tables with adjusting
screw (3.2).
• Re-tighten counternut (3.8) and handle (3.1).
7 Adjusting the parallelism of sliding table
guide and saw blade
7.1 Checking the parallelism
• Fit angle fence on sliding table.
• Set stop guide so that the front edge of the stop
is exactly fl ush with the outer table edge of the
PRECISIO. When the sliding table is moved the
edges must be equidistant throughout the entire
range of motion.
7.2 Adjusting the parallelism
The parallelism is adjusted with the screw (3.5) on
the fi tting angle on the rear of the table.
• Loosen handle (3.1).
• Loosen locking bolt (3.7)
• Loosen counternut (3.6).
• Adjust parallelism with screw (3.5).
• Check by moving the sliding table - same dis-
tance to base table at all points!
• Re-tighten locking bolt (3.7), counternut (3.6)
and handle (3.1).
8 Fitting the legs (Fig. 4)
• Release handle (4.2).
• Place legs (4.5) vertically on the fl oor.
• Tighten handle (3.4).
9 Extra clamp for stop guide (Fig. 4)
• Insert extra clamp (4.4) from rear into one of the
three table grooves.
• Pivot clamping piece (4.3) into groove on rear of
stop and tighten with rotary knob (4.1).
10 Dismantling the sliding table unit
The complete sliding table can be dismantled in
a trice and quickly be re-fi tted with no adjust-
ments.
• Fold away legs (4.5).
• Lock sliding table with rotary knob (6.5).
• Release handles (3.1) and remove from frame
with bolt head (5.2).
• Remove complete unit.
Re-assemble in reverse order with no adjust-
ments.
9