Store The Machine - STERWINS 20VGS2-13.1 Manual Del Usuario

FR 5. TRANSPORTATION
Transporting the machine may require that you meet certain requirements specific to your
country. Please make sure to respect them by contacting the authorities of your country, in
ES
order to respect them all.
Plug out the battery from the power tool. Let the machine cool for 2 hours outside before
transport it. Secure the product by removing the blade. Ensure temperature during
transportation will never be out of temperature range given on chapter storage. Protect the
PT
product from any heavy impact or strong vibrations which may occur during transportation in
vehicles. Secure the product to prevent it from slipping or falling over.
6. WINTERING & STORAGE
IT

6.1 STORE THE MACHINE

Plug out the battery from the power tool. Let the machine cool for 2 hours outside before storing
EL
it. Be sure to secure the unit while transporting (remove the blade). Examine the unit thoroughly
for worn, loose or damaged parts. Clean the product before storing.
Only store the machine in a clean, dry, ventilated place with a temperature range of 4°C to
PL
24°C. Cover it in order to provide added protection. Do not expose the product to sunlight. Make
sure the product is always protected from cold and humidity. We recommend using the original
package for storage or covering the product with a suitable cloth or enclosure to protect it
against dust.
RU
6.2 STORE THE LITHIUM BATTERIES
Please make sure that the battery power level is as recommended in the battery instruction
manual. Store the battery in a clean, dry, ventilated place sheltered from the sunlight. We also
KZ
recommend using the original package of the battery to protect it against dust. Please refer to
the battery instruction manual for further details.
7. MAINTENANCE
UA
7.1 CLEANING
RO
EN
Cleaning the product : illustration 5.1
Plug out the battery from the power tool. Let the machine cool for 2 hours outside before
cleaning it. Take the blade out of the blade latch.
Keep all safety devices, air vents, and motor housing free of debris and dirt. Wipe down the
equipment with a cloth. It is highly suggested that you clean the device after every use. Do not
use cleaning agents, as these can attack the plastic and weaken the structural integrity of the
product.
WARNING ! DO NOT HANDLE CUTTING PARTS WITHOUT GLOVES
AS THEY ARE SHARP AND CAN BECOME HOT AFTER USE,
POTENTIALLY CAUSING PERSONAL INJURY.
172