Regular Maintenance; To Test The Bark Control Collar - Petsafe GUARDIAN anti-bark collar Manual De Funcionamiento

becomes quiet, he will not receive any more static corrections. The small minority of dogs that have this
reaction will only have it the first time they wear the Bark Control Collar.
You should notice a reduction in your dog's barking within the first couple of days that he wears the
Bark Control Collar. At this point, it is important to remember the learning process is still not complete.
Dogs will "test" this new learning experience and will increase their attempts to bark. This usually occurs
during the second week a dog wears the Bark Control Collar. If this does occur, remain consistent and
do not alter your use of the Bark Control Collar. You must place the Bark Control Collar on your dog in
every situation when you expect him to be quiet. If your dog is not wearing the Bark Control Collar, he
may resume barking and his learning would suffer a setback.

Regular Maintenance

• Check Contact Points for tightness weekly Note: Do not adjust the factory preset
Sensor Probe.
• Clean Contact Points with alcohol weekly Note: Remove the battery and
discharge the Bark Control Collar before touching the Contact Points.
• Check your dog's neck for irritation and wash neck weekly.

To Test the Bark Control Collar

Slide the Sensor Probe across a rough surface for at least 10 inches. The Bark Control
Collar should beep. If your Bark Control Collar doesn't beep during this test, see
"The Bark Control Collar does not beep" in the "Troubleshooting" section, and
continue with the second step.
www.guardianpet.net 1 1