LAMP HEAD
1.
Pry open the front cover with a flathead screwdriver.
(See Figure 3)
Figure 3
Front Cover
NOTE: Backup battery is included with unit and
can be used in case of power outage.
WALL
1.
Punch out the appropriate mount screw holes and
cable hole from the back plate. (See Figure 5)
2. Feed transformer input leads through cable hole
and make the proper connections. (See Figures 1-2)
3. Mount back plate to wall. (See Figure 5)
Figure 5
Mount
Screw Holes
PAGE 2 OF 12
ASSEMBLY
2. Insert the lamp heads at the corners of the main
3. Connect the male connector on lamp head to
MOUNTING
4. Select appropriate pictogram from packaging.
Back Plate
Cable Hole
frame. (See Figure 4)
NOTE: Select the direction of the lamp heads
before inserting. Lamp heads can be placed
facing forward or facing backward.
female connector on unit. (See Figure 4)
Female
Figure 4
Connector
Male
Connector
Assemble on the unit.
NOTE: The pictogram should insert in the gap
of diffuser and face plate. (See Figure 6)
Figure 6
Face Plate
Diffuser
Lamp Head
LAMP
HEAD
Main Frame
Gap
0321 IH-9283