Uline Н-9283 Guia De Inicio Rapido página 4

3. Attach crossbar to junction box. (See Figure 13)
4. Route the proper wires through mounting hole of
housing, canopy and crossbar. (See Figure 13)
5. Make the proper electrical connections inside the
junction box. (See Figures 1-2)
6. Push excess wire into junction box. Use provided
screws to tighten canopy to crossbar so that canopy
is securely fastened and tight against the ceiling.
(See Figure 13)
Figure 13
Junction Box
Mounting Hole
PAGE 4 OF 12
MOUNTING CONTINUED
7.
Figure 14
Crossbar
Canopy
1-800-295-5510
uline.com
Select appropriate pictogram from packaging.
Assemble on the unit.
NOTE: The pictogram should insert in the gap
of diffuser and face plate. (See Figure 14)
Face Plate
Diffuser
Gap
0321 IH-9283