Uline Н-9283 Guia De Inicio Rapido página 3

SIDE
1. Remove the mounting hole cover on the side of the
unit. (See Figure 9)
2. Attach the canopy by inserting it into the housing at
a 20° angle and twist clockwise. (See Figure 9)
Figure 9
Mounting
Hole Cover
3. Attach crossbar to junction box. (See Figure 10)
4. Route the proper wires through mounting hole of
housing, canopy and crossbar. (See Figure 10)
5. Make the proper electrical connections inside the
junction box. (See Figures 1-2)
6. Push excess wire into junction box. Use provided
screws to tighten canopy to crossbar so that canopy
is securely fastened and tight against the wall.
(See Figure 10)
Figure 10
PAGE 3 OF 12
MOUNTING CONTINUED
Canopy
Mounting Hole
Crossbar
Canopy
Junction Box
7. Select appropriate pictogram from packaging.
Assemble on the unit.
NOTE: The pictogram should insert in the gap
of diffuser and face plate. (See Figure 11)
Figure 11
Face Plate
Diffuser
CEILING
1. Remove the mounting hole cover on the top of the
unit. (See Figure 12)
2. Attach the canopy by inserting it into the housing at
a 20° angle and twist clockwise. (See Figure 12)
Figure 12
Mounting Hole
Canopy
0321 IH-9283
Gap