Media Installation And Removal; Roll Media Installation Procedure - Seiko I Infotech Inc SII IP-7700 Guia De Inicio Rapido

Media installation and removal

Roll media installation procedure

The installation method of the scroller fl ange varies with the type, weight and take-up direction of the media. See the tables
below to install the scroller fl ange correctly.
This section describes the installation procedure without using the scroller shaft.
For how to use the scroller shaft, see P.49.
General media
Media weight
Media print surface
Flange spacer
Scroller shaft
Vinyl chloride media
Media weight
Media print surface
Flange spacer
Scroller shaft
1
Put the media on the table.
If you want to use a dolly, contact us. We have a
recommend product.
2
Install the scroller fl ange into each end of the
media roll.
(1) Insert the scroller fl ange into each edge of the paper
tube.
Scroller fl ange
40
Less than 35kg
Inner take-up media Outer take-up media
Required Required
Not required Not required
Less than 35kg
Inner take-up media Outer take-up media
Not required Not required
-
Not required
35kg to 50kg
Inner take-up media
Required
Required
P.49
35kg to 50kg
Inner take-up media
Not required
Required
P.49
(2) Insert the fl ange spacer between the scroller fl ange
and the media roll.
Flange spacer
Note
- When PVC media is used, push the scroller fl ange until it
stops without inserting the fl ange spacer.
- The fl ange spacer should be inserted to the position
indicated by the line B.
Be careful not to deform it by applying too much force.
B
Outer take-up media
Required
Required
P.49
Outer take-up media
Not required
Required
P.49
A