Operation; Getting Started - Workzone WMW 300-1 Manual Del Usuario

Plunge-cut saw blade
Example of use: Sawing slots.
1. Place the plunge-cut saw blade
The blade of the saw blade must be pointing forward (see fig. L).
2. Place the washer
3. Use the Allen wrench
Scraper
Example of use: Removing coatings, lacquer coats or floor surfaces.
1. Place the scraper
2. Place the washer on the top of the plunge-cut saw blade with the concavity up.
3. Use the Allen wrench to tighten the Allen head screw.
Segment saw blade
Example of use: Flush cutting fitted door frames to length.
1. Place the segment saw blade
2. Place the washer on the top of the plunge-cut saw blade with the concavity up.
3. Use the Allen wrench to tighten the Allen head screw.
Sanding plate
Example of use: Grinding surfaces in inaccessible corners.
1. Place the sanding plate
2. Use the Allen wrench to tighten the Allen head screw. The washer is not
required to mount the sanding plate.
3. Place the sanding sheets
Push firmly so that the Velcro backing holds in place.

Operation

Getting started

1. Make sure that the multifunction tool has been properly prepared as de-
scribed in the chapter "Preparing the multifunction tool".
2. Connect the multifunction tool to a power plug.
3. Switch the extractor on.
4. Use the On/Off switch
5. Use the speed control
trol to level 1 for low vibration (oscillation) and to level 6 for intense vibration
(oscillation). Make sure that you use the correct speed for the work material or
test various speeds on the work material to determine the correct one.
AFTER SALES SUPPORT
USA
10
on the plunge-cut saw blade with the concavity up.
8
to tighten the Allen head screw
14
on the tool holder at any angle (see fig. L).
11
on the tool holder at any angle (see fig. L).
12
on the sanding plate so that they are aligned.
1
to switch the multifunction tool on.
3
to adjust the speed (see fig. F). Set the speed con-
1 866 326-6446
15
on the tool holder
13
on the tool holder at any angle (see fig. L).
meister-service@meister-werkzeuge.de
Operation
16
at any angle.
9
.
USA
15