Repair; Troubleshooting - Workzone WMW 300-1 Manual Del Usuario

USA

Repair

Repair
WARNING!
Risk of electric shock!
Repairs performed by the user or the use of unsuitable spare
parts to repair the device poses an increased risk of electric
shock.
− Do not open the housing. In the event of a defect, only
have the multifunction tool repaired by authorized qual-
ified professionals. For this, contact the manufacturer at
the service address specified on the warranty card. Electric
and mechanical parts, which are essential for providing
protection against sources of danger, are contained in this
multifunction tool.
− Do not attempt to perform any repairs by yourself.
− If the connection line is damaged, you must – in order to
avoid risks – have it replaced by the manufacturer or its
customer service representative.

Troubleshooting

Some malfunctions may be caused by minor faults, which you can resolve
yourself. Follow the instructions in the following table for this.
If it is still not possible to resolve the problem with the multifunction tool,
contact customer service.
Problem
1.
The handle/
tool cannot
be mounted.
18
meister-service@meister-werkzeuge.de
Possible cause
The inside thread is
dirty.
The washer, the Allen
head screw, the Allen
wrench or the tool is
bent/damaged.
Troubleshooting
Always keep the inside thread
clean as described in the chapter
"Cleaning and maintenance".
Contact the customer service
team of the manufacturer and
have the damaged or defective
part replaced.
AFTER SALES SUPPORT
USA
1 866 326-6446