Bosch GKF125CE Instrucciones De Funcionamiento Y Seguridad página 11

Ocultar thumbs Ver también para GKF125CE:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GKF125CE 2610040765 09-15_GKF125CE 9/3/15 12:01 PM Page 11
FIG. 9
A
DEPTH SCALE
Rotate the knurled wheel clockwise to
increase the routing depth, counterclockwise
to decrease the cutting depth. Each
complete rotation of the dial equals 1.25 mm
(approximately 3/64").
3. Turn the clamping knob to the bottom,
locked position
(E, Fig. 9). Always make
sure the motor sits tightly in the base.
4. Check the depth-of-cut and make an
additional fine adjustment if necessary.
Note: the depth of the motor and bit may shift
very slightly when the clamping knob is turned
to the locked position.
5. Make a trial cut to verify that the router is set
to make the cut as desired.
All manuals and user guides at all-guides.com
C
B
For deep cuts, make several progressively
deeper cuts by starting at one depth and then
make several subsequent passes, increasing
the cutting depth with each pass.
To be certain that your depth settings are as
desired, you may want to make test cuts in
scrap material before beginning work.
-11-
E
MOTOR
BASE
CLAMPING KNOB
D
KNURLED WHEEL
DEEP CUTS

Publicidad

Tabla de contenido
loading

Tabla de contenido