Troubleshooting - Sunny SF-E3914 Manual Del Usuario

target calorie before training by pressing the SET & MODE button. Each setting increase is 1 cal.
Automatically counts down from targeting value during exercise.
Note : This data is a rough guide which cannot be used in medical treatment.
8. ODOMETER:
Displays the total accumulated distance from 0 to 9999 M (Miles). User can also press mode key to
display the odometer value.
9. PULSE:
The computer will display the user's heart rate in beats per minute during training.
Note : This data is a rough guide which cannot be used in medical treatment.
10. RESET:
Press the button and hold for 3 seconds to reset all value except odometer to zero.
NOTE:
1. If the computer display is abnormal, please re-install the new batteries and try again. Always
change both batteries at the same time. Do not mix battery types and do not mix old and new
batteries.
2. Battery Spec: 1.5V UM-4 or AAA (2PCS).
3. Dispose the batteries safely, according to your state and regional guidelines.
PROBLEM
There is no display on the
meter
The elliptical
wobbles when in use
The elliptical
makes a squeaking noise
when in use.

TROUBLESHOOTING

1. Remove the computer and verify that the wire from the
computer is properly connected to the wire that comes from the
upright post.
2. Check if the batteries are correctly positioned and that the
battery springs are in proper contact with batteries.
3. The batteries in the computer may be unresponsive. Change to
new batteries.
climber Turn the adjustable end caps on the rear stabilizer as needed to
level the elliptical climber.
climber
The bolts may have become loosened on the elliptical climber.
Please inspect all the bolts and tighten any that may have loosened.
SOLUTION
18
Version: 1.2